水流量的大小由三種方式控制，增減泵頭的內徑，或延長或縮短柱塞的行程。 增減柱塞的往復速度。 大多數高壓清洗機使用一套閥門和泵頭組成系統，柱塞將水拉到供水閥門，施加壓力使其通過出水閥門。 通過閥門兩側不同的壓力差完成壓力操作。閥門通過防止逆流來控制水通過泵。 閥門由彈簧和托架構成， 作用于閥門的壓力大于彈簧的能力時，閥門就會打開。 在相反的行程中，水自動將支架壓在閥座上，使閥保持關閉，防止逆流。 了解了這個原理，就知道該如何操作這個清洗設備了。

The size of water flow is controlled by three methods: increasing or decreasing the inner diameter of the pump head, or extending or shortening the stroke of the plunger. Increase or decrease the reciprocating speed of the plunger. Most high-pressure cleaning machines use a system of valves and pump heads, with a plunger pulling water to the supply valve and applying pressure to pass it through the outlet valve. Complete the pressure operation through different pressure differences on both sides of the valve. The valve controls water flow through the pump by preventing reverse flow. The valve is composed of a spring and a bracket, and when the pressure acting on the valve exceeds the capacity of the spring, the valve will open. In the opposite stroke, the water automatically presses the bracket onto the valve seat, keeping the valve closed and preventing reverse flow. By understanding this principle, you will know how to operate this cleaning device.

由于噴淋清洗機通過高壓水流去污，使用高壓清洗機清洗也是目前世界上科學、經濟、環保的清洗方法。 因此，在進行工業清洗時，采用這樣的清洗設備性價比高，清洗效果好。

Due to the use of high-pressure water flow for cleaning by spray cleaning machines, using high-pressure cleaning machines for cleaning is currently a scientific, economical, and environmentally friendly cleaning method worldwide. Therefore, when conducting industrial cleaning, using such cleaning equipment has a high cost-effectiveness and good cleaning effect.

噴淋清洗機的結構：

The structure of the spray cleaning machine:

1、高噴淋清洗機外部采用鍍鋅和不銹鋼外殼，采用不銹鋼或(角通)骨架焊接，清洗機上蓋部分采用單層結構，由1.2mm厚的不銹鋼板制作，外貼保溫層，降低能耗。 箱體采用單層結構，內部配有PU淋浴管，封閉通過式通道。 為全封閉結構，實現洗滌液過濾、鐵屑沉淀、油過濾、油分離;由SUS304不銹鋼1.2mm厚的不銹鋼板制作; 內部由隔板分為幾個區域，水箱設有水分補給口、排液口、溢水口。

1. The exterior of the high spray cleaning machine is made of galvanized and stainless steel shell, welded with stainless steel or (angle through) framework. The upper cover of the cleaning machine adopts a single-layer structure, made of 1.2mm thick stainless steel plate, with an external insulation layer attached to reduce energy consumption. The box adopts a single-layer structure, equipped with PU shower pipes inside, and enclosed through channels. For a fully enclosed structure, achieving washing solution filtration, iron filings precipitation, oil filtration, and oil separation; Made of SUS304 stainless steel 1.2mm thick stainless steel plate; The interior is divided into several areas by partitions, and the water tank is equipped with water supply ports, discharge ports, and overflow ports.

2 、噴淋清洗機的底部兩側向中央傾斜，清洗液從容器底部的排液口集中排出。 罐內設有液位控制器，液位異常時應立即注意補水、停水。 溫度自動控制在10~90的范圍內，手動設定、自動控制。有溫度計的自動顯示。 罐外貼上保溫棉，異常情況實現緊急停止。 防銹箱的內部設置有不銹鋼電熱加熱器，在30~60分鐘內使液體從室溫上升到使用溫度。防止熱量散發。

2. The bottom sides of the spray cleaning machine are tilted towards the center, and the cleaning solution is centrally discharged from the discharge port at the bottom of the container. There is a liquid level controller inside the tank, and in case of abnormal liquid level, immediate attention should be paid to replenishing and stopping water. The temperature is automatically controlled within the range of 10-90, manually set and automatically controlled. Automatic display with thermometer. Stick insulation cotton on the outside of the tank to achieve emergency stop in abnormal situations. The interior of the rust proof box is equipped with a stainless steel electric heater, which can raise the liquid from room temperature to service temperature within 30-60 minutes. Prevent heat dissipation.

噴淋清洗機的原理帶來的好處：

The principle of spray cleaning machine brings benefits:

在所有清洗方式中，是與獨特的工作原理和清洗方法密切相關的。 雖然像平時一樣在生產和生活中，需要清洗的東西很多，需要清洗的種類和環節也很多，噴淋清洗機是效率高、效果統一的方式。 噴淋清洗機之所以能達到這樣的效果， 噴淋清洗機操作簡單，故障少，但是淋浴清洗機可以批量清洗工件，效果統一，控制性高，成本低，可以進行大量連續自動作業。清洗效果統一。高壓淋浴清洗機的應用范圍：

Among all cleaning methods, it is closely related to the unique working principle and cleaning method. Although there are many things that need to be cleaned in production and daily life, as usual, and there are also many types and processes that need to be cleaned, the spray cleaning machine is an efficient and uniform method. The reason why the spray cleaning machine can achieve such an effect is that the operation of the spray cleaning machine is simple and there are few faults. However, the shower cleaning machine can clean workpieces in batches, with unified effects, high control, low cost, and can perform a large number of continuous automatic operations. Uniform cleaning effect. The application range of high-pressure shower cleaning machine:

噴淋清洗機廣泛應用于各行各業，電機行業：電機外殼清洗。 適用于簡單的結構和管件產品的清洗。五金行業有廚師、水槽、家電產品有限公司。 民間行業：餐盤、洗碗、浴巾、毛巾批量清洗。

Spray cleaning machines are widely used in various industries, including motor casing cleaning. Suitable for cleaning simple structures and pipe fittings. There are chefs, sinks, and home appliance products limited companies in the hardware industry. Folk industry: Batch cleaning of dinner plates, dishes, bath towels, and towels.